Bondtech LGX Lite No Motor
**motor is not included**
The Bondtech LGX Lite without motor is a premium filament feeder based on the LGX Large Gears eXtruder and uses Bondtech’s new Dual Drive Technology based on larger drive gears. Here are some features of the Bondtech LGX Lite Extruder without motor:
- stronger housing
- increased resistance to heat
- and that Bondtech black Look
- Larger drive wheels for increased filament grip
- Filament pre-tension lever for repeated results on rigid and flexible materials
- Drive wheels’ maintenance windows for easy cleaning
- Compact, light & centered filament path for increased performance and compatibility
- Multiple mounting hole patterns for an easy and flexible setup
- Compatible with Nema14 round stepper motors
- Craft boxes without bleaching & no coating
- Nylon housing with no dyeing or other chemical post-processing
The Bondtech LGX Lite Extruder without motor is compatible with the LGX Lite Mount for use with Mosquito or Copperhead Hotends.
Technical Specification
- e-steps value : 562 using 16 microsteps; 1124 using 32 microsteps.
- Drive wheels : hardened steel;
- Materials compatibility : abrasive; rigid; semi-flexible; flexible; and soft.
- Mounting holes : M3
- Mounting patterns : bottom (4 points); right (2 points), front to motor (2 points), top (1 point)
- Hole at the top of the LGX® Lite : 5 mm depth
- Holes on the side of the LGX® Lite : 5 mm depth
- Holes on the bottom of the LGX® Lite : 5 mm depth
- Max tightening torque on the extruder screws is 0.3 Nm
For Klipper users
rotation_distance = full_steps_per_rotation * microsteps / steps_per_mm
rotation_distance = 200 * 16 / 562
rotation_distance = 5.7
The above calculation assumes the following parameters:
- stepper motor is a 1.8 degrees motor hence 200 as full steps per rotation
- microsteps are set to 16
- e-steps value recommended for the LGX® Lite is 562
- retraction speed : 35 mm/s
- retraction distance (bowden) : ~5 mm (0.4 + tube length[mm] x 0.015)
- retraction distance (direct drive) for rigid materials : 0.4 mm
- retraction distance (direct drive) for soft materials : 3 mm
- Max Environment operating temperature : 90°C
- LGX® Lite net weight : 48 g
- Package measurements : 80x103x73 mm
- Package weight : 85 or 185 g
Each LGX Lite extruder is supplied with
- 1x LGX® Lite feeder
- 1x 2mm Hex Key (recommended tool);
- 1x Powered By Bondtech sticker.
Also shipping with additional accessories
- 1x Push-fit collar
- 1x 30mm PTFE tube to use in the PTFE Tube Adapter.
- 8x M3 square nuts for reinforcing mounting holes.
Reviews
There are no reviews yet.