E3D Revo Micro Hotend Kit 24v
The E3D Revo Micro Hotend kit is the next revolutionary hotend E3D has developed. When compared to the V6 hotend it’s predecessor it can print much faster due to it new design and provide more consistency as well. Say no more to leaks and tools as the nozzle is now integrated into the heatbreak and the nozzle only needs to be finger tightened during installation!
Ready for Revo. Change nozzles at room temperature using just your fingers. No complex tools, no hot tightening. Revo Nozzles are a factory sealed nozzle and heatbreak in one, so they’re easy to fit and can’t leak material when in use.
New hotness. A Revo HeaterCore heats up in seconds. It’s much safer too – unlike other solutions on the market, a positive temperature coefficient (PTC) means the Revo HeaterCore can not melt at extreme temperatures: power reduces as it gets hotter, so hazards are reduced in the event of a thermal runaway.
Runs cool, looks cool. With an anodised black heatsink, not only does Revo Micro run cool – it looks cool, too.
Flexible to any setup. Revo Micro plays nice with Bowden and direct drive setups, but its lightweight construction makes it an ideal choice for Bowden setups.
Please note:
– This kit does not include any 3D printed mounts
– The Revo Micro fan must be connected using the 5V regulator unless connecting directly to a 5V pin
Revo Kits Include
- Revo Micro Heatsink
- M12 x 1.5 nut
- 2010 5v Fan
- 24v to 5v regulator for fan
- Revo Micro Fan Duct
- Collet
- Collet Clip
- Revo HeaterCore 24v
- Revo HeatCore Spring
- Extension Cable Kit
- 100mm PTFE
Single Kit Includes
- 0.4mm Revo Brass Nozzle
Fully Loaded Kit Includes
- 4 Revo Brass Nozzles (1 of each size in 0.25mm, 0.4mm, 0.6mm, 0.8mm)
Reviews
There are no reviews yet.