LDO Voron 2.4 Motor Kit with CW2 Motor

The LDO Voron 2.4 Motor Kit with CW2 Motor is a full LDO 7 motor kit used for building a Voron 2.4 3D Printer.

**This kit includes the LDO-36STH20-1004AHG(VRN) motor.
This is the motor used for Clockwork 2 (CW2) in the Stealthburner and other popular extruders such as the LGX Lite.

Kit Includes

Qty 1 – LDO-36STH20-1004AHG(VRN) – datasheet

• NEMA 14
• 10 Tooth Gear
• Rated Temp: 180C
• 1.8° Step Angle
• 200 Steps Per Revolution
• 1 Amp
• 100 mNm Holding Torque
• 20mm Body
• 500mm wire lead with XH Connector

QTY 2 – LDO-42STH40-2004MAH(VRN) – datasheet

• NEMA 17
• Rated Temp: 180C
• .9° Step Angle.
• 400 Steps Per Revolution
• 2.0 Amp
• 3.5Kgf cm Holding Torque
• 40mm Body.
• 22mm Output Shaft (5mm diameter)
• Includes 50mm lead with Molex Microfit 3 termination

Qty 4 – LDO-42STH48-2004AC(VRN) – datasheet

• These are the z Motors and are not High Temp motors as it is not required but do include a cable plug to the motor
• NEMA 17
• Rated Temp: 100C
• 1.8° Step Angle
• 200 Steps Per Revolution
• 2 Amp
• 5.9Kgf cm Holding Torque
• 48mm Body
• 24mm Output Shaft (5mm diameter)