Voron Trident Cast Aluminum Build Plate 9.5mm

Our Voron Trident Cast Aluminum Build Plate 9.5mm is made with 5083 aluminum. These are high precision plates that have been blanch ground to MIC6 specs on both sides.

For MIC6 plates under 12mm thickness, flatness tolerances are +/-0.4mm and is measured across the entire 5′ x 10′ sheet of aluminum. Once these sheets are cut down to smaller sizes the flatness tolerances tighten up a lot and many plates are below 0.2mm and some are even under 0.1mm. I don’t charge extra for this but it is the luck of the draw. What is important is getting a quality magnet and Spring Steel sheet as these are the final layers and can cause deviations as well on the final print surface and a thick cast aluminum plate will help prevent with any warping as the plate heats up.

These build plates are not multi Voron combination plates and do not have the additional holes along the edges that are the industry standard sold by many stores. By removing the holes you may experience better heating performance when printing close to the edge. Less is better in this case.

We know these plates look so nice when they arrive but for best results before installing build plates ensure that you use a scotch bright or something to scuff up both sides of the plate to ensure best adhesion of the heated mat and the magnetic sheet.

**Please note this plate will not fit a Voron 2. Holes are drilled specially for Voron Trident printers. If you are looking for a Voron 2 plate please click here.

Features
Plate thickness: 9.5mm
Material: Aluminum cast plates
Composition: 5083 Aluminum
Thickness tolerance: +/- 0.1mm
Flatness: <=0.4mm
Cut Dimensions: +/-3mm