Voron 0 Cast Aluminum 8mm Build Plate

Our Voron 0 cast aluminum 8mm build plate is made with 5083 aluminum. These are high precision plates that have been blanch ground to MIC6 specs on both sides.

For MIC6 plates under 12mm thickness, flatness tolerances are +/-0.4mm and are measured across the entire 5′ x 10′ sheet of aluminum. Once these sheets are cut down to smaller sizes the flatness tolerances tighten up a lot and many plates are below 0.2mm and some are even under 0.1mm. I don’t charge extra for this but it is the luck of the draw. What is important is getting a quality magnet and Spring Steel sheet as these are the final layers and can cause deviations as well on the final print surface and a thick cast aluminum plate will help prevent any warping as the plate heats up.

We know these plates look so nice when they arrive but for best results before installing build plates ensure that you use a scotch bright or something to scuff up both sides of the plate to ensure the best adhesion of the heated mat and the magnetic sheet.

Features
Plate thickness: 8mm
Plate Width: 120mm
Plate Height: 120mm
Material: Aluminum cast plates
Composition: 5083 Aluminum
Thickness tolerance: +/- 0.1mm
Flatness: <=0.4mm
Cut Dimensions: +/-3mm